Repair Why Is My Gas Hot Water Heater Not Working Tutorial

Home > Water Heater > Why Is My Gas Hot Water Heater Not Working

Why Is My Gas Hot Water Heater Not Working

Contents

We had the plumber out and he can't figure it out. See How to Light a Gas Furnace Pilot for similar operation.Re-tighten, reposition or replace the gas thermocouple.Replace the gas pilot control valve. 2 of 7 Show All 1 How to Repair Photo 1: Unscrew the nuts Turn off the control valve and the shutoff. Solution is to raise the supply air temperature, stored water temperature or even tank size (make sense if the existing one is too old, and low performing). navigate here

Hot flue gases run though the flue pipe located in the middle of the tank and transfers the heat to the surrounding water, making it warmer and finally hot. After a couple hours I cut off the pilot valve to off and then closed the gas supply valve. Or is this some kind of a local US standard? A water heater that is not supplying enough hot water can change your mood and, worse, make you worst that something may be wrong with your heater.

Gas Water Heater Thermocouple

I have a electric heater in garage Reply ↓ levab Post authorJune 16, 2016 at 12:14 pm Chris, 1) Hot water heater does not produce COLD water. 2) Even on coldest Idioma: Español Ubicación del contenido: España Modo restringido: No Historial Ayuda Cargando... and heater ignited to heat water. You might also enjoy: Sign up There was an error.

DIY Tinker 933.371 visualizaciones 8:39 Water Heater Pilot Light Will Not Light Up - Duración: 8:18. References (2) hometips.com: Water Heating Troubleshooting And RepairAmerican Society of Home Inspectors: The Temperature Pressure Relief Valve About the Author Gus Stephens has written about aviation, automotive and home technology for While enjoying your warm shower, you feel the water suddenly becoming cold! Gas Water Heater Leaking To minimize the energy it takes to heat the water, insulate your water pipes if they run a long way from your heater to your faucets.

Any suggestion? Repairing dip tubes on water heaters that are out of warranty is seldom cost effective. This same thing happened when we first drained the tank a few days ago but the shower drip stopped after a few hours.

If this doesn't solve the problem, the anode rod may need replacement.

That is the best advice I can give. Gas Water Heater Troubleshooting No Hot Water Any help on what the problem could be? Note the present setting (or mark it with a felt-tip pen), and then turn it toward a cooler setting, wait a couple of hours, and see if the problem is solved. Clearly, the first thing to do if your hot water is too hot is turn down the temperature on the water heater's thermostat dial.

  • We never had any problems.
  • And I cannot think about any logical reason to make devices warm the cold water up, aside from getting more gas consumed 🙂 so what's the point?
  • Paul Avelluto I admire the valuable information you offer in your blogs.
  • Make sure you are not getting overcharged.
  • Seems my tank was filling and draining nonstop so I shutoff the in and out lines to the tank and no more noise.
  • Photo Credit: DIGIcal / Getty Images Water Leak Around Base of Heater:Possible CausesFaulty T&P (temperature and pressure) relief valve T&P valve leak due to excessive pressure, overheating or stuckLeak from overhead
  • If the gas is turned off at the gas meter, at the shutoff valve leading to the heater or if the control knob on the heater is turned to the “off”

Gas Water Heater Pilot Light Won't Stay Lit

Thermocouple Dish soap Long matches(for lighting pilot) Popular How-To Videos Email a Friend Send link to this project to a friend, along with a personal message. If that is the case, wait for water heater to recover. Gas Water Heater Thermocouple Her father came over, and I found out it was just the hot water relief valve. Hot Water Heater Pilot Won't Light Did you mean ?

So to much gas for sure any suggestions why? check over here Ever since it was installed over a month ago the water temperature has been scalding hot. Is it covered by insurance? Be sure to turn off the shutoff valve in the gas line; that is, one quarter turn so that the handle is at a right angle to the pipe. No Hot Water How To Fix

I had already replaced the thermocouple before doing this. Maybe something is wrong with pipes or valves after hot water leaves the tank. In hopes of a quick response and spend all day on the hold; with PWS and Health department; Monday; I wanted to ask the following. his comment is here Reply ↓ Paul March 28, 2015 at 6:54 pm I had a sooting problem and after I cleaned the burner orfice and burner the soot problem stopped.

Hot Water Is Discolored or Smells Bad If your water has a strange odor, first determine whether the problem is with the source water or the water heater. My Water Heater Is Not Heating Water What was done to repair it? Also, my water bill increased $40 since noticing it.

Another bacterium is Legionella, which thrives in mildly warm water.

Smith Energy Saver Gas Automatic Water HeaterTroubleshooting a Water Heater OverflowWhat Would Cause a Bathroom to Not Get Hot Water in the Tub Only? I hope someone can help me. Transcripción La transcripción interactiva no se ha podido cargar. Hot Water Heater Gas Valve Reply ↓ Cameron August 3, 2016 at 4:33 pm What if you have hot water and pressure but not to a specific area?

To get rid of them, perform a yearly maintenance and flushing of your hot water heater. There is not a leak, and the water heater continues to work well. Sometimes I'll try a faucet and get hot water then later in the day or the next day I'll try the same faucet and the water is cold and will not http://codebuz.com/water-heater/water-heater-rv-not-working.html Replace faucet with same pipe thread type and open water inlet valve to refill and open a hot side faucet in sink to let air out, when water comes out it

Seeking HELP! When the new tank was installed the gas usage went down again. We had a hot water heater in a few rent houses put in the garage and the contractors had to have the heaters on level approximately an inch and a half. HD Supply Facilities Maintenance 48.831 visualizaciones 27:48 How to relight a water heater pilot light - Duración: 4:09.

And sooner or later you will need to replace it. My mother-in-law mentioned something about that the other and was panicking. Photo 2: Remove the assembly Pull out the burner assembly. Good luck and be careful.

Unscrew drain tube from the valve. Mostrar más Cargando... If you are handy, you can replace this part yourself. For draining and tank flushing, there is a drain valve at the bottom of the tank.

Low gas pressure or a malfunctioning gas control valve could also cause a pilot light to go out repeatedly. Janice Grahovac It is gas shadow1458 Replaced the thermocoupler, lit the pilot, the burner came on then went out after a few seconds. How to Troubleshoot Rotten egg odor Milky/Rusty water Noise problem Pilot light goes Out Removing sediments Temperature fluctuation Water hammer Leaking Failure signs Bulging Condensation Home Reviews Best Blog Reviews by Relit several times and kept going out, does anyone know what causes this?

The service man claims that the new magnesium rod is causing a release of hydrogen gas in the water because of the reaction between sodium, magnesium, and chloride. It could be that the heater’s thermostat is defective. Release the valve handle. When I hold down the gas button the thermal coupling will lights but the burner will not catch fire.